1967-1972 Chevelle, Malibu Convertible Pump Grommets, Filler Plug

Description

For all 1967-1972 GM A body cars (Chevelle, Tempest, LeMans, GTO, Cutlass, 4-4-2, Skylark) - Convertible Top Pump Rubber Mounting Feet Grommets and Reservoir Filler Plug.
How to install: Lubricate the point of the grommet with oil or transmission fluid. Or it may be easier to raid the 'fridge and use Crisco or cooking oil or olive oil.
You will need a tool - a round rod a bit smaller than the hole in the top of the grommet.  Make sure the end of the rod is not       pointy - otherwise you will pierce the rubber plug.  An ideal tool can be made by grinding off the pointed end of a Phillips         screw driver so that the end is either flat or slightly rounded. (A good use for that crappy screw driver with the mutilated end.)
Place the point of the grommet in the hole in the pump mount. Insert the rod you made into the hole in the top of the                 grommet. Push the rod into the hole, stretching the grommet so that it slides the hole.  Easy after you have done a couple.         Then use the same technique to mount the pump to the car.
1 Year Warranty
Free shipping in the USA.
Hydro-E-Lectric has been providing quality made products since 1976.
We carry a full line of convertible top and power window parts for U.S. cars from 1946 through present day.
We ship WorldWide on a daily basis.
Contact us about combined shipping rates.
We accept Visa, MasterCard, American Express, Discover or PayPal.
"How do I get the air out of my hydraulic system"?
Remove the reservoir plug on the motor pump.  Leave the plug out and do not put back until you have finished.
Fill the reservoir 3/4 full with fluid (to the bottom of filler plug hole).  Put a rag under the hole to catch overflow that will occur as system fills.
Run the pump for 5-10 seconds.  Stop.  Check your fluid level and refill to bottom of filler hole.  Continue running the motor in the same direction for an additional 5-10 seconds.  When the top gets to the end of cycle, check your fluid level, fill to bottom  of filler hole, and run the motor in the opposite direction.
You are literally running the top all the way up and down several times. Checking the fluid level as you go and fill as required, leaving reservoir 25%  empty.
When you are no longer able to add fluid, put the top in the down position. Check the fluid level one last time, should be to bottom of filler hole. Put the plug into reservoir.
For all your interior needs, visit allautointeriors on ebay